The trap should be 6 to 18 inches above the floor. Standpipes are available with built-in traps or can be assembled using standard drainpipe and elbow fittings. Lever-style washing machine shut-off valve. With this type, you just flip the lever to shut off the water supply. Just be sure to turn the valve on before running the washer. Scoot the appliance into place. Level the top of the machine, adjusting its front feet as needed. How do I hook up a washing machine drain line to this box?
How to Install a Washing Machine
How am I supposed to hook up the waste line? Do I need to drill out that center hole? Tester k 54 Interesting box; I haven't seen that before. Is the intent to catch any potential leak from the hot and cold water connections, or is this just intended to permit pretty installation behind wallboard? Pretty installation behind wallboard. As a side issue, did the plumber install any shut-off valves on the hot and cold supplies, upstream of the connection points shown? User Per the product info sheet there should be shut-offs in there, it looks like they're just not visible due to the angle of this photo.
No idea how well it actually works, though. Tester Tester k 54 The spec sheet for the box claims "Oversized KOs will not fall down drain". I'm not sure know how that actually works here though. You can also cover the knockout with tape, with a wire or string under the tape.
How Much Does a Washer-Dryer Hookup Cost?
This would allow you to retrieve the knockout if it falls into the drain. AndrewMedico Yeah that certainly doesn't look oversized in this case. However that may have something to do with GuestPost's answer - the box appears to be upside-down, and the port on the bottom now top seems to be larger and could potentially have a larger KO. Just my best guess though. Saved my bacon with this post.
- Your Answer!
- dating caribbean?
- im dating someone younger?
- Want FREE Home Tips & Hacks?!
- hugo becker and leighton meester dating?
- How to Set Up Laundry Room Plumbing!
- lebanese online dating?
To keep it from falling in, I drove a wood screw into it and tied some twine to the top, and the other end to my thumb. Whacked edge with screwdriver, pried it out, done. GuestPost GuestPost 31 1. You can just barely see the tip of the shutoff valve handle to the left of each open threaded connection. They're integral to the fitting. I would say it's two sided and not upside down. Just pop that plug and hang the hose there. Nice touch having the water hammer reducers installed. I have them on mine too.
Keith E Keith E 11 1. That's not an "S" trap, it's a "P" trap. They can be installed "at any angle" per the mfgr website: Screw the machine's supply lines to the valves and tighten with pliers.
How to Install Washer & Dryer Connections | Home Guides | SF Gate
Drape the drain hose over the side of the utility sink and clamp it firmly in place. With lots of water flowing in and out, a laundry room needs to be plumbed correctly.
Learn how with our plans for setting up laundry room plumbing. Find a Pro Get help from one of our recommended professionals. How to do it. Step 1 Cut Pipe.
Step 2 Set Tee Fitting. Step 3 Attach Stub Outs.
Step 4 Attach Hose Bibs. Step 5 Assemble Sink. Step 6 Run Pipes. Step 7 Install Washing Machine.