Drain hook up kitchen sink

Apply rubber gasket, cardboard ring and metal fastener to the underside of sink drain and tighten. Remove the excess plumbers putty from inside sink bowl around the drain. Repeat this whole process if your sink has more than 1 drain.

Installing Kitchen Sink Drain Pipes | Home Guides | SF Gate

Roughly install the drainage pipe. Do not glue black ABS drainage pipe while roughly installing the pipe. Locate the drain pipe coming from the floor or wall and rough in your drainage pipe from your kitchen sink drain to the drainage pipe.

Be sure to include a P-trap located as close to the drainage pipe that is coming out of the wall or floor as possible. Include a dishwasher drain attachment if needed. Location and orientation of drain pipes differ from job to job. Disassemble drain configuration and lay it out in the design that it will be installed.

Install the drainage pipe.

1. How to Install a Kitchen Sink Drain (with Pictures) - wikiHow.
2. best dating website leeds?
3. muslim dating dk?
4. arrangement finders dating?
5. free weed dating site?

Starting from the drainage pipe coming out of the wall or floor begin gluing the piped piece by piece ensuring proper orientation. Read the ABS cement cautions and labels before use. ABS cement dries within seconds after pieces are inserted together. For more information, see Bathroom Sink Plumbing. Underneath the sink, a rubber gasket, metal washer, and large locknut or retainer tightens the body to the sink.

A straight tailpiece mounts to the strainer body with a threaded coupling. Slip-joint couplings connect the tailpiece, the main parts of a drain trap, and a short threaded nipple at a tee in the drainpipe.

You have successfully subscribed! Thanks from the HomeTips Team.

At the wall or the back of the cabinet, a trim piece called an escutcheon hides the connector and the nipple. Waste water exits through the trap and down the vented drainpipe to the main stack. A sink trap is a J-shaped pipe beneath a sink, designed to trap noxious sewer gases before they enter the house. The trap arm should be installed below a straight pipe attachment.

Installing Kitchen Sink Drain Pipes

The trap arm should be fitted to the drain-stub, which is done using a suitable washer, and a slip nut. The washer usually has a beveled edge which then can be installed against the side of the drain stub.

• dating sites for journalists?
• How to Hook up a Double Kitchen Sink Drain Part 1!
• dating love confessions?
• the online dating manifesto?
• dating site in johannesburg?
• speed dating in stroud?
• Tools List for Installing the Plumbing for a Kitchen Sink.

Once the drain is added, you can then attach a small piece of pipe known as a tailpiece to the end of the drain below the sink. Screw this into place using the nut, and then add the T-fitting to this tailpiece using a slip washer. Level it up to the bevelled edge of the washer, s that it grips the pipe tightly.